87
MAINTENANCE SCHEDULE
(1) Lubricate more frequently when used in salt water.
(2) These items should be serviced by your servicing dealer, unless you have the proper tools and are mechanically proficient. Refer to the
TOHATSU Service Manual for service procedures.
(3) For professional commercial use, log hours of operation to determine proper maintenance intervals.
(6) When there is 1/3 or more consumption, please exchange.
Each use After use
First
month or
20 hrs.
Every 6
months or
100 hrs.
Every
year or
200 hrs.
Every 2
years or
400 hrs.
Refer to
page
Engine oil Check level o 42
Change o o 89
Gear case oil Change o (2) o (2) —
Engine oil filter Replace o (2) —
ACG belt Check-adjust o (2) —
Throttle linkage and Control Cable Check-adjust o (2) o (2) —
Idling speed Check-adjust o (2) o (2) —
Valve clearance Check-adjust o (2) —
Spark plug (nickel) Check-adjust/Replace o 90 – 93
Spark plug (iridium)
(Optional part)
Check o94
Clean o (2) —
Replace o—
Propeller and cotter pin Check o 46
Anode metal (Outside engine) Check o 49
Anode metal (Inside engine) Check/Replace o (2) (6) —
Lubrication Grease o (1) o (1) 95, 96
Fuel filter with water separator
(Low pressure side)
Check o o 97
Replace o98
Fuel filter
(High pressure side)
Replace
o (2) —
REGULAR SERVICE PERIOD (3)
Perform at every indicated month
or operating hour interval,
whichever comes first.
ITEM
MAINTENANCE
36ZVTT00_EN.book 87 ページ ２０２１年１１月１９日 金曜日 午後３時２１分
To Next Page
