EasyManua.ls Logo

TOHATSU BFT 150D - Page 93

TOHATSU BFT 150D
130 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
91
MAINTENANCE
<Standard Spark Plug>
Check-clean/Replace interval:
Every 100 operating hours or 6
months.
Recommended spark plug:
ZFR6K-11 (NGK)
KJ20DR-M11 (DENSO)
Use only the recommended spark
plugs or equivalent. Spark plugs
which have an improper heat range
may cause engine damage.
<Inspection and Replacement>
1. Disconnect the battery negative (–)
terminal.
2. Unlock and remove the engine
cover (see page 41).
3. Remove the two bolts with the
6 mm hex wrench, and remove the
spark plug cover.
4. Use a hex. wrench to remove the
bolt holding the ignition coil. Move
the ignition coil to a position that
allows to remove the wire
connector easily.
SPARK PLUG COVER
BOLTS
36ZVTT00_EN.book 91 ページ 2021年11月19日 金曜日 午後3時21分

Table of Contents