INSTALLATION28
5
z Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
z Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
z Always use a fully charged battery.
ENOW00015-1
Do not use a battery that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to the electrical system.
ENON00006-1E
Note
Minimum battery requirements: 12v
64Ah/5HR, 12v 70Ah/20HR, 512 Cold
Cranking Amps (CCA).
Larger capacity battery is required when it
is used under a freezing condition.
Recommend connecting only the engine
battery cables to the starting battery.
Specifications and features of battery vary
by manufacturers. Consult the manufac-
turer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Place the battery box in a convenient
position away from possible water and
moisture. Securely fasten both the
box and the battery so they do not
shake loose.
2. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on it
to prevent short circuits.
1. Battery cord (red)
2. Battery cord (black)
CAUTION
To Next Page
Loading...
