REMOVING AND CARRYING THE OUTBOARD MOTOR 59
8
through the exhaust port and cause
engine problems.
Keep the outboard motor in a vertical
position when carrying.
The optional outboard motor stand is
recommended for keeping the outboard
motor vertical both during transport and
storage.
ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
ENOM00072-C
ENOW00072-0
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
Close air vent screw of fuel tank and fuel
cock before carrying or storing outboard
motor and fuel tank, or fuel may leak, poten-
tially catching fire.
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
ENOF01727-0
3. Trailering
CAUTION
WARNING
WARNING
CAUTION
ENOF00680-0
To Next Page
Loading...
