ENGINE OPERATION56
7
ENOM00068-A
ENOW00051-0
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the clamp bracket. Be sure to
tilt the outboard motor down slowly.
ENOW00053-0
While in shallow water drive position, do not
operate the outboard motor in Reverse.
Operate the outboard motor at slow speed
and keep the cooling water intake sub-
merged.
ENOW00054-1
Do not over tilt the outboard motor when
driving in shallow water, or air may be sucked
through water inlet and sub-water inlet,
potentially leading to engine overheating.
1. Water inlet
2. Sub-water inlet
Manual tilt type
1. Shallow water running position:
Put the reverse lock lever in the tilt up
position, and tilt up the outboard
motor to put the outboard motor in
the shallow water running position.
1. Reverse lock lever
2. Tilt down position
3. Tilt up position
2. Return to normal running position:
Put the reverse lock lever in the tilt
down position, slightly lift up the out-
board motor, and then put it down.
1. Reverse lock lever
2. Tilt down position
3. Tilt up position
10.Shallow water operation
WARNING
CAUTION
CAUTION
1
2
3
ENOF00059-0
1
2
3
ENOF00059-0
To Next Page
Loading...
