ENGINE OPERATION 53
7
4. Remove the thrust rod as show pic-
ture.
1. Push in
2. Rise the stopper
3. Pull out
5. Reinstall the thrust rod in the desired
position securely.
6. Gentry tilt down the outboard motor.
Trim angle adjustment
(Power Trim & Tilt type)
The transom angle adjustment
1. Stop the engine.
2. Shift into neutral position.
3. Tilt up the outboard motor.
4. Lock the Tilt stopper.
1. Snap pin
2. Thrust rod
5. Remove the Snap pin and thrust rod
as shown picture.
6. Reinstall the thrust rod in the desired
position securely.
7. Put the snap pin back and unlock the
tilt stopper.
8. Gentry tilt down the outboard motor.
ENOM00060-A
ENOW00055-1
Do not tilt the outboard motor up or down
when swimmer(s) and/or passenger(s) are
near to prevent them from being caught
between outboard motor body and clamp
bracket.
ENOW00048-1
When tilting up or down, be careful not to
place your hand between the swivel bracket
and the clamp bracket.
ENOW00056-A
When tilting up outboard motor with fuel
joint for over a few minutes, be sure to dis-
connect fuel hose, or fuel may leak, poten-
tially catching fire.
ENOW00057-1
Do not tilt up the outboard motor while
engine is operating, or no cooling water may
be discharged, leading to engine seizure due
to overheating.
1
2
ENOF01147-0
1
2
ENOF01147-0
9. Tilt up and down
WARNING
WARNING
WARNING
CAUTION
To Next Page
Loading...
