28
● Data clear
Press MEM to save the tightening mode and proceed to next. (Press C key to return to tightening
mode setting.)
* If you change the tightening mode, tightened data will be deleted. Transfer the necessary data to
PC or Printer in advance.
（Data clearance display）
● Snug torque setting（Default : 0）
Set the snug torque. This is the torque from which the angle tightening starts to count.
Use key to select the digit, and change values with key. Press MEM key to confirm and
proceed to the next (Press MD key to proceed without saving. Press C key to return to RUN
measuring mode).
● Tightening angle setting (Default : 000)
Set the tightening angle (the angle starting from the snug torque to the final tightening
angle).
Use key to select the digit, and change values with key. Press MEM key to confirm and
proceed to the next (Press MD key to proceed without saving. Press C key to return to RUN
measuring mode).
● Tightening angle upper limit setting (Default: 000)
Set the upper angle limit counting from the snug torque.
To Next Page
Loading...
