Click Upgrade Firmware below to automatically identify and upgrade the
positioning board firmware, tilt module firmware, and device firmware. There will be
a prompt below during the upgrade process, and the device will restart after the
upgrade is complete. The operation steps are as follows:
1. Click [Upgrade Firmware];
2. Select the correct device firmware in the pop-up window, flash the firmware
and wait for the device to restart;
3. After the restart is complete, the firmware upgrade is finished;
4. Reconnect the device WiFi, enter the WebUI, and check whether the firmware
has been upgraded successfully.
3.3 Skyplot
① Skyplot: Trace, Name, Health, Elev, Azim;
To Next Page
Loading...
