58
NOTE: Both fuse damage and none output of test
signal caused by signal source fault will make “FUSE”
alarm.
Quick Start Guide
CAUTION
• Do not measure a capacitor that is not fully
discharged. Connecting a charged or partially
charged capacitor to the input terminals will
damage the instrument.
• When measuring an on-board component within a
circuit, the circuit must be powered off before
connecting the test leads.
• When used in a dusty environment, the instrument
should be wiped and cleaned regularly. The
electrical conductivity carried by the accumulated
dust will eventually have an effect on the use of the
meter.
To Next Page
Loading...
