31
Data Record Mode (REC)
If the data stability of tested components is poor and
the data fluctuates in a range, data record mode can
aid the reading of data.
This mode is used for dynamically recording
maximum, minimum, and average values in a range.
Enable Static Recording
Press and hold down the REC button for a long time
to enter the data recording mode. The display should
indicate “MAX AVG MIN” simultaneously, which
indicates the meter is in static recording mode.
Using Static Recording
There are four different modes that can be selected in
static recording. Per press of the REC button (in
recording mode, FREQ will disable), the modes will
change and repeat in the following order:
Recording Mode
Maximum Mode Minimum
Mode
Average Mode
To Next Page
Loading...
