37
10% or 20%, which will be shown on LCD
accordingly.
7. Changing test component, an audible tone will
be heard. One single “beep” or tone means
the component is within tolerance. Three
“beeps” or tone means the component is out
of tolerance.
WARNING: Be sure that the capacitor has
been fully discharged before its test, or the
instrument might be damaged.
Disable Tolerance Mode
Long press of TOL button will disable tolerance mode.
NOTE: Changing the test frequency, primary function,
or secondary function will automatically disable
tolerance mode.
Auto LCR Mode
Auto LCR function will automatically select the
corresponding primary and secondary parameters and
suitable series/parallel equivalent mode of L, C, R.
The selection is done by judging the impedance
To Next Page
Loading...
