64
Resistance Measurement
1. Press the POWER button for a long time to turn
on the instrument.
2. Press the L/C/R/Z button until “R” is displayed on
the screen to select inductance measurement.
3. Insert a resistor into test slots or connect a tested
resistor through a proper test accessory (e.g.,
banana plug-crocodile clip test leads, test fixture
or SMD test tweezers). See figure 15. And figure
14 shows the optional 4-terminal test accessories.
4. Press FREQ button until the desired test
frequency is displayed on screen.
5. Press the D/Q/θ/ESR button to select the desired
secondary parameter.
6. Read the readings on LCD for resistance
measured values.
NOTE: The meter uses an AC signal for
measurement of resistance, so what the test result
shows is AC resistance property instead of DC
resistance property.
To Next Page
Loading...
