33
Average Display
Press REC button until the “AVG” indicator is shown
on display. This indicates that the value in the primary
display represents the recorded average value.
Disable Static Recording
To exit this mode, press and hold the REC button for
a long time. All the “MAX”, “MIN”, or “AVG” indicator
will disappear on LCD.
NOTE: Changing the type of test parameters will
automatically turn off static recording.
L/C/R/Z Select Mode
To select measurement mode, you should select
primary parameter first.
Each press of the L/C/R/Z button, the parameter will
change and repeat as the following modes:
L (inductance), C (capacitance), R (resistance), and Z
(impedance).
NOTE: After changing primary mode, secondary
display indicates the present frequency. If it is
required to display corresponding secondary
parameters, press the secondary button.
To Next Page
Loading...
