Need help?Do you have a question about the Tonghui TH2822 and is the answer not in the manual?
Summary of safety precautions for operating and maintenance personnel.
Guidelines to ensure safe operation of the device.
Explains symbols used for warnings and power indicators.
Details of the LCD display and its indicators.
Identifies and explains the functions of the meter's buttons.
Comprehensive guide to all elements on the LCD screen.
Explains specific error and status messages on the display.
Describes the 3-terminal and 5-terminal test ports.
Instructions for inserting the correct battery type.
Steps for powering the meter using an AC adapter.
How to interpret and respond to low battery warnings.
Information on using and controlling the LCD backlight.
Explains charging status indication for rechargeable models.
How to freeze and display measurement data.
Capturing maximum, minimum, and average readings.
Selecting the primary measurement parameter (L, C, R, Z).
Selecting secondary parameters like Dissipation, Quality Factor.
Setting the AC signal frequency for measurements.
Using the mode for component sorting based on percentage deviation.
Automatic selection of measurement parameters and modes.
Choosing between fast and slow measurement speeds.
Selecting the appropriate circuit model for components.
Configuring meter settings like beep, power-off timer, and power-up state.
Performing open/short clear for measurement accuracy.
Controlling the meter remotely via PC interface.
Identifying and responding to blown fuse indicators.
Important safety cautions before operation.
Step-by-step guide for measuring inductance.
Step-by-step guide for measuring capacitance.
Step-by-step guide for measuring resistance.
Step-by-step guide for measuring impedance.
Procedures for establishing PC connectivity via USB.
Settings for serial communication with the PC.
Managing remote control and auto fetch modes.
Overview of SCPI commands for controlling the instrument.
Explains command format variations and case sensitivity.
Describes basic commands like *IDN?, *LLO, *GTL, *TRG.
Details SCPI command structure for frequency, function, and calculation subsystems.
Key technical parameters and features of the instrument.
General notes and details on measurement accuracy.
Accuracy data for L and Q measurements across ranges.
Accuracy data for C and D measurements.
Accuracy data for Z and θ measurements.
Guidance on troubleshooting and professional servicing.
Procedures for safely cleaning the LCR meter.
General| Brand | Tonghui |
|---|---|
| Model | TH2822 |
| Category | Measuring Instruments |
| Language | English |
To Next Page
