70
Remote Mode
Upon the acceptance of any commands from PC, the
meter will be automatically set into remote mode. In
this mode, the LCD display will show “RMT” indicator.
When this is shown, all front panel button will be
locked and disabled, except for RMT and POWER
buttons. If the meter has been in Auto Fetch mode
before receiving remote control commands, Auto
Fetch mode will be disabled.
That is to say, among panel operation, Auto Fetch and
Remote Control, remote control has the highest
priority.
To exit remote control, press the RMT button. When
the “RMT” indicator disappears on the LCD display,
the meter goes back to local operation.
NOTE: If the local operation is locked, RMT button
will be ineffective as well. See *LLO common
command in Command Reference section for details.
Press RMT button to change to Auto Fetch state,
when it is not in the remote mode. See the description
below.
Auto Fetch
When the meter is out of remote control, it can be
changed to Auto Fetch mode. That is, the meter will
To Next Page
Loading...
