ToolKitRC M6D - Page 27

@ ToolkitRC 2020
27
To end the charge and discharge work, short press
[OK], move the cursor to [Stop working], short press
[OK], stop work and return to the main interface.
When charging is completed or an error occurs
during charging, a prompt box pops up and a tone
sounds.
Display content description:
24.00V：
Input power supply voltage
9A：Input power current
20.0Wh：Total power consumption of input power
45.0℃：
Charger internal temperature.
V: Constant pressure sign. C：Constant current sign.
F: Current limit sign. P: power, I: Input overcurrent, C:
Maximum current, A: Activate charging, F: The main
port is full voltage or a single chip is full voltage.