@ ToolkitRC 2020
Quick start
1，Connect a 7-28V power supply or input battery to
the input port on the back of the M6D.
2，The display shows the boot logo and stays for 2
seconds.
3，At the same time accompanied by do-re-mi's boot
sound.
4，After booting, the display will enter the main
interface and display as follows:
5，Short press [Exit], the cursor switches between the
left and right channels.
6，Press and hold [EXIT] to start testing the internal
resistance of the corresponding channel. After the test,
the internal resistance will be displayed.
7，Scroll [Scroll Wheel] to switch the pages in the
To Next Page
Loading...
