To Next Page

To Previous Page

3.1.3

3.1.3 Single-step

Single-step

Single-step execution

execution

In the Actl Run(Actual running) or Mt Run(Empty running) state, if SS

Mo(Single-step mode) is not chosen, the system default is in the program continuous

running mode and the SS Mo(Single-step mode) key color is not negative display. If

press the left F3 key corresponding to SS Mo(Single-step mode), the SS

Mo(Single-step mode) key color is negative display and in the Actl Run(Actual

running) or Mt Run(Empty running) state, program runs with Single-step mode. Each

step of the program running is controlled by the St(Start) key on the controller panel

or the external input line St(Start) defined in the IO set(IO settings) area of Pars Set

(Parameters settings) area. Press the key, the current file executes a line of program,

press again, then continues to execute next line of program.

3.1.4

3.1.4 TrmtProg(Terminate

TrmtProg(Terminate

TrmtProg(Terminate program)

program)

In the program pause or running state, by pressing this key, the program stops

and jumps to the first line of the program in the AutoExec(Automatically execute)

interface.

3.2

3.2 Man

Man

Man Op(Manual

Op(Manual

Op(Manual operation)

operation)

In the main interface, press the left F2 key to enter the Man Op

（

Manual

operation

）

interface.

Topcnc TC5510 User Manual

Questions and Answers: