axis reference points, Electronic gear, Increase speed time, Jog increment, the axis
gaps, a lot of speed parameters of the axises.
3.4.1.1
3.4.1.1
3.4.1.1
3.4.1.1 CtrlPars(Control
CtrlPars(Control
CtrlPars(Control
CtrlPars(Control parameters)
parameters)
parameters)
parameters)
When enter the Sys Pars(System parameters) interface, the default is
CtrlPars(Control parameters). Or in the Sys Pars(System parameters) interface, press
the left F1 key to enter the CtrlPars(Control parameters) interface.
CtrlPars Control parameters
Spd Pars Speed parameters
FacVal Factory value
SavePars Save parameters
XAxs RP X-axis reference point
XAxsNmr X-axis numerator
XAxsDnmn X-axis denominator
IncrSpdTime(ms) Increase speed time (ms)
JogIncre(micron) Jog increment (micron)
XAxsGap(micron) X-axis gap (micron)
Through the ‘↑’‘↓’‘ PgUp ’‘ PgDn ’ keys on the controller panel, move the cursor to
find the parameter need to be modified
，
and edit or modify the parameter. Through
pressing the left F4 key corresponding to SavePars(Save parameters) and then
pressing the Cfm(Confirm) key on the controller panel according to the prompt, save
To Next Page
Loading...
