Topcnc TC5510 - Page up Instruction; Page down Instruction

In the ProgMgmt(Program Management) interface, press the left F1 key to enter
the Ed Prog(Edit program) interface. In this interface, we can modify or rebuild the
read-in file or the last open file before the shutdown.
PgUpInst Page up instruction
PgDnInst Page down instruction
Ins 1Row Insert a row
Del 1Row Delete a row
Lin M Linear motion
Lbl Label
Abs M Absolute motion
PTP M Point to Point motion
End End
3.3.1.1
3.3.1.1
3.3.1.1
3.3.1.1 PgUpInst(Page
PgUpInst(Page
PgUpInst(Page
PgUpInst(Page up
up
up
up instruction):
instruction):
instruction):
instruction): In the current line number, through this key,
we can page up all Instruction Names controlled and applied by the controller.
Example:
In the interface,
n001 Lin M File:1144
press PgUpInst once, then becomes
n001 Abs M File: 1144
That is, in the n001 line
，
modify the old Lin M(Linear motion) instruction to the Abs
M
（
Absolute motion
）
instruction, and new instruction parameter shows
simultaneously.
3.3.1.2
3.3.1.2
3.3.1.2
3.3.1.2 PgDnInst(Page
PgDnInst(Page
PgDnInst(Page
PgDnInst(Page down
down
down
down instruction):
instruction):
instruction):
instruction): In the current line number, through this
key, we can page down all Instruction Names controlled and applied by the controller.