To Next Page

To Previous Page

defined is when the external output line changes, the program can not be modified,

just the parameter is modified simply.

Note: The FacVal(Factory value), Save functions and application methods are the

same as the above (Sys Pars(System parameters)).

3.4.4

3.4.4 Usr

Usr

Usr Mgmt(User

Mgmt(User

Mgmt(User management)

management)

In the Pars Set(Parameters settings) interface, press the left F4 key to enter the

Usr Mgmt(User management) interface. The system default is in the UsrLogin (User

3.4.4.1

3.4.4.1 UsrLogin

UsrLogin

UsrLogin (User

(User

(User login)

UsrLogin User login

Mod Pwd Modify password

Usr Quit User quit

PlsEntrPwd Please enter the password

PrsCfmToCfmInp Press the Confirm key to confirm the input

After entering the user password and pressing the Cfm(Confirm) key, if enter

correctly, the prompt is Usr Login OK(User login successfully), if not, the prompt is

Pwd Err Pls Entr Agn(Password mistake, please enter again). The factory value of the

user password is 123456. After the user logs in successfully, the processing

parameters can be modified and saved. Otherwise the processing parameters can not

be modified and saved.

Example: If need to modify the parameters, firstly, the user must log in. The

password is 123456.

Topcnc TC5510 User Manual

Questions and Answers: