Topcnc TC5510 - IO Set (IO Settings)

The program output point setting is wrong
The output signal is not normal
3.4.3
3.4.3
3.4.3
3.4.3 IO
IO
IO
IO Set(IO
Set(IO
Set(IO
Set(IO settings)
settings)
settings)
settings)
In the Pars Set(Parameters settings) interface, press the left F3 key to enter the
IO Set(IO settings) interface. The system default is in the InpPars (Input parameters)
setting interface.
3.4.3.1 InpPars (Input parameters)
InpPars Input parameters
OutpPars Output parameters
Sv Save
X+Lim X-axis positive limitation
X-Lim X-axis negative limitation
Proh Prohibited