Topcnc TC5510 - Page 34

Note:
Note:
Note:
Note: when
when
when
when there
there
there
there is
is
is
is no
no
no
no change,
change,
change,
change, may
may
may
may be
be
be
be as
as
as
as follows
follows
follows
follows
24V power supply is not working properly
The output signal line connection is not normal
The corresponding relay is not working properly
3.4.2.4
3.4.2.4
3.4.2.4
3.4.2.4 ProgOutp(Program
ProgOutp(Program
ProgOutp(Program
ProgOutp(Program output)
output)
output)
output)
In the Sys SC (System self-check) interface, press the left F4 key to enter the
ProgOutp(Program output) interface.
Through pressing the ← , → , ↑ , ↓ cursor keys to change the selected program
output point, move the cursor. Press the Cfm(Confirm) key, the corresponding state
changes from O(Off) to I(On), or from I(On) to O(Off). At the same time the
corresponding output will change from open to closed, or from closed to open.
Note:
Note:
Note:
Note: when
when
when
when there
there
there
there is
is
is
is no
no
no
no change,
change,
change,
change, may
may
may
may be
be
be
be as
as
as
as follows
follows
follows
follows