Topcnc TC5510 User Manual

ExtStart(External start) is set N.O.( Normally open) and input port is set 3. Through
switching on the external input port 3, the St(Start) status should change from O(Off)
to I(On) on the second page of the controller interface.
Note:
Note:
Note:
Note: when
when
when
when there
there
there
there is
is
is
is no
no
no
no change,
change,
change,
change, may
may
may
may be
be
be
be as
as
as
as follows
follows
follows
follows
The input point setting is wrong
The input signal is not normal
3.4.2.3
3.4.2.3
3.4.2.3
3.4.2.3 ActlOutp(Actual
ActlOutp(Actual
ActlOutp(Actual
ActlOutp(Actual output)
output)
output)
output)
In the Sys SC (System self-check) interface, press the left F3 key to enter the
ActlOutp(Actual output) interface.
PrsCfmToChgOnOff Press the Confirm key to change On or Off
Through pressing the ← , → , ↑ , ↓ cursor keys to change the selected actual
output point, move the cursor. Press the Cfm(Confirm) key on the controller panel,
the corresponding state changes from O(Off) to I(On), or from I(On) to O(Off). At the
same time the corresponding output will change from open to closed, or from closed
to open.

Topcnc TC5510 Specifications

General

Brand	Topcnc
Model	TC5510
Category	Controller
Language	English