Topcnc TC5510 User Manual

Actl Inp Actual input
Set Inp Setting input
ActlOutp Actual output
ProgOutp Program output
O off
I on
Tst Actl Inp Test actual input
Note:
Note:
Note:
Note: when
when
when
when there
there
there
there is
is
is
is no
no
no
no change,
change,
change,
change, may
may
may
may be
be
be
be as
as
as
as follows
follows
follows
follows
24V power supply is not working properly
The input signal line connection is not normal
3.4.2.2
3.4.2.2
3.4.2.2
3.4.2.2 Set
Set
Set
Set Inp(Setting
Inp(Setting
Inp(Setting
Inp(Setting input)
input)
input)
input)
In the Sys SC (System self-check) interface, press the left F2 key to enter the Set
Inp(Setting input) interface.
X+Lim X positive limitation
X-Lim X negative limitation
Tst Set Inp Test setting input
Alm Alarm
Stop Emergency stop
XZero X zero
St Start
Paus Pause
IcSp Increase speed
RdSp Reduce speed
Through controlling the external input ports on/off, detect whether or not the set
input ports are valid and accurate corresponding.
Example: In the IO Set(IO settings) area of the Pars Set(Parameters settings) area,

Topcnc TC5510 Specifications

General

Brand	Topcnc
Model	TC5510
Category	Controller
Language	English