18
USING THE INSTRUMENT
3 When transposing is required
Press TRANS button, and the astigmatism symbols will
change.
Press the button again, and the original data will reappear.
4 When storing
Press the MEMORY button . will turn to .
When R/L designation is required
Press the R/L button.
In the screen, appears in this order.
For example, is displayed.
5 When printing (with printer specification)
Press PRINT button. When connecting with computer, data is transmitted.
MEASURING A FRAMED LENS
1 Pull the lens table to your side.
2 Gently, place the glass frame against the lens table for
measurement.
Alignment Place the frame against the lens table
gently, and move the frame vertically
and horizontally finely.
• When ( R/L is not displayed):
Press the button.
First align the right lens and press the Memory button .
Press the button.
Align the left lens and press the Memory button .
• When & is set ( R/L is displayed):
*Measurement of framed lens.
First, align the right lens to display “MARKING OK”. Then the result is automatically memo-
rized, when the right lens is hold.
Removing the right lens will automatically move to the L measurement.
Align the left lens, then the result is automatically memorized, when the left lens is hold.
• When & is set:
*Measurement of single lens/framed lens
Press the button. ( R/L is displayed)
At first, align the right lens to display "MARKING OK". Then the result is automatically mem-
orized, when the right lens is hold.
Removing the right lens will automatically move to the L measurement.
Align & hold the left lens. The result is automatically memorized.
S: -1.50 S: -1.00
C: +0.50 C: -0.50
A: 90 A: 180
Holding the lens table back
side, place the glass frame
simultaneously.
AUTO R/L OFF
AUTO
AUTO R/L / R/L AUTO MEMORY/ON AUTO
AUTO R/L S/R/L AUTO MEMORY S:OFF R/L:ON
AUTO
To Next Page
Loading...
