41
SPECIFICATIONS
SYSTEM CLASSIFICATION
• Type of protection against electric shocks: Class I equipment
Class I equipment does not depend on basic insulation only for protection against electric
shocks. It can also be earthed; therefore, the metal parts with which one comes into contact
do not become conductive if the basic insulation fails.
• Degree of protection against harmful ingress of water: IPx0
CL-200 has no protection against ingress of water. (The degree of protection against harmful
ingress of water defined in IEC 60529 is IPx0)
• Classification according to the method(s) of sterilization or disinfection recommended by the
manufacturer: not applicable.
• Classification according to the degree of safety of application in the presence of a flammable
anaesthetic mixture with air or with oxygen or nitrous oxide: Equipment not suitable for use in
the presence of a flammable anaesthetic mixture with air or with oxygen or nitrous oxide. CL-
200 should be used in environments where no flammable anesthetics and/or flammable gases
are presents.
• Classification according to the mode of operation: Continuos operation.
Continuos operation is the operation under normal load for an unlimited period, without the
specified limits of temperature being exceeded.
OPTIONAL ACCESSORIES
Steel needle marking set (steel needle, supply ink, inkpot, holder)
ORDERING CONSUMABLE SUPPLIES AND SPARES
Product name Part code No. Remark
Spare part Fuse T 4A 250V:100-240V 42038 9004 Standard accessory
Consumables Marking ink cartridge (3 cartridges/set) 42036 9950 Standard accessory
Lens protection pad 42036 5800 Standard accessory
Steel needle marking set 42036 2510 Optional accessory
Supply ink 42036 9006 Optional accessory
Printer paper 44800 4001
With printer specification
To Next Page
Loading...
