Topcon CL-200 - Printing Additional Textbox (with Printer Specification)

28
USING THE INSTRUMENT
PRINTING ADDITIONAL TEXTBOX (WITH PRINTER SPECIFICATION)
On the print out with the measuring data, the user can input his own text, like office name,
address or special message. The available space is three line of 20 characters each.
Select and press the button below the icon , and the world of
marking of text will appear (as shown at below).
: Moves to the left the cursor in Section A.
: Moves to the right the cursor in Section A.
: Moves to the left where to write in Section B.
: Moves to the right where to write in Section B.
: Writes the character in Section B.
Upon completing Section B, move the cursor to END of Section A and press , and writ-
ing may be possible, returning the measurement screen. Once the characters are written,
they will remain even after the instrument power is turned off.
Take care that the polar coordinates are not the same as the value on the angular
scale in the target image.
• When the unit is mm.
Select .
The marks show the optical center
reaches the center of measurement by moving
the lens in the arrow directions by the distance
as displayed.
3.0mm
2.0mm
0 will be displayed if the spherical power S is around 0.
MENU/PRISM/mm
MENU/NAME/SET
Section A Section B
(Characters to be written)
1 2 3 4 5
1
2
3
4
5