14
Introduction
• When the fractional/decimal display format is set to "0.001m" and
the unit of measurement is "m", the display is as follows:
• When the fractional/decimal display format is set to "0.001ft" and
the unit of measurement is "ft", data is displayed as follows:
When measuring mode is "Single", "Average" or "Repeat"
Height: Up to 3 decimals
Distance: Up to 1 decimal
When measuring mode is "Tracking"
Height: Up to 2 decimals
Distance: 0 decimal
• When the fractional/decimal display format is set to "0.01ft" and the
unit of measurement is "ft", data is displayed as follows:
When measuring mode is "Single", "Average" or "Repeat"
Height: Up to 2 decimals
Distance: Up to 1 decimal
When measuring mode is "Tracking"
Height: Up to 1 decimal
Distance: 0 decimal
• When the fractional/decimal display format is set to "1/8" and the
unit of measurement is "inch", the display is as follows:
When measuring mode is "Single",
"Average" or "Repeat"
Height: Up to 3 decimals
Distance: Up to 2 decimals
When measuring mode is "Tracking"
Height: Up to 2 decimals
Distance: Up to 1 decimal
When measuring mode is "Single",
"Average" or "Repeat"
Height: **-**-*/
*
Distance: **-**
When measuring mode is "Tracking"
Height: **-**-*/
*
Distance: **
DL502-503.book 14 ページ ２０１０年４月５日 月曜日 午前９時４７分
To Next Page
Loading...
Need help?
General
