• Point number input
Step 4: Press to ready the instrument for point
number input.
Step 6: Press twice to ready the instrument for
point number input.
(See "8.4 Flow of Recording Data".)
• Attribute setting
Step 6:
Press to ready the instrument for attribute
setting. (See
"8.4 Flow of Recording Data"
.)
• Go and Return setting
Step 4:
Press to display the Go and Return Setting
Screen. (See
"8.3 Double-run Measurement"
.)
• Storing backsight elevation
Steps 3 and 10: Even after power off, backsight elevation is
stored or turning point is stored as the next
backsight elevation. Since this value is the
same as the value in the setting out elevation
mode, the backsight elevation is stored to
whichever mode is set last. (See "11.3 Setting
Out Elevation".)
• Reviewing stored data
Steps 4 and 6:
Press to display the contents of the
selected JOB. (See "13.1
Data Check and Edit"
.)
• Manually inputting measurement data
Steps 4 and 6: Press . Measurement data can now be
input manually. (See "8.4 Flow of Recording
Data".)
Notes:
To Next Page
Loading...
Need help?
General
