Indicates Battery Power Remaining
Measurement is possible.
The power is poor. The battery should
be recharged or replace
the battery.
(Angle measurement can only be possi-
ble, the auto-collimating and distance
measurement can not be possible.)
Measurement is impossible. Need to
recharge or replace the battery.
* Battery power remaining display is omitted in this manual.
Note:
1) The battery operating time will vary depending on the environmental conditions, such as
ambient temperature, charging time, and the number of times charging and discharging
the battery.
2) In low temperature (especially while the heater of display is working), the battery operating
time will shorten to one-half of normal temperature use.
3) The indicator for battery power remaining shows the power level during each measurement
mode. The condition indicated for the battery power remaining in the angle measurement mode
may not be adequate to measure a distance. Changing from angle mode to distance mode
during a poor battery condition may cause the EDM not to measure a distance. We recommend
that you check the battery condition before going into the field.
4) Also note, when changing from one measurement mode to another, the battery indicator
may not show a decrease or an increase immediately. The battery indicator system was
designed to show the general condition for the battery strength. It does not respond
instantly.
5) For more information on battery usage, refer to Chapter 13
“POWER SOURCE AND CHARGING”.
To Next Page
Loading...
Need help?
General
