22-2
22 ERROR DISPLAYS
● If error still persist after attempting to clear them, contact your local Topcon dealer or Topcon head
office.
PT# EXIST
Same new point name is already memorized
in the memory.
Confirm the new point name and input
again.
PT# DOES
NOT EXIST
When you enter incorrect name or PT# does
not exist in the internal memory.
Enter the correct name or enter point in the
internal memory.
RANGE
ERROR
When setting a new point, calculation is
impossible from the measured data.
Measure again.
Tilt Over
Instrument tilts over more than
3 minutes.
Level the instrument properly.
V ANGLE
ERROR
H ANGLE
ERROR
VH ANGLE
ERROR
Abnormality in angle measuring system.
If this error code continues to display, repair is
required.
To Next Page
Loading...
