9168 Control Box
P/N 7010-0781
7-9
9168 Control Box
This section lists possible 9168 control box problems you may
encounter. If you still have problems after trying the solutions listed
here, contact TPS customer support.
Problem
Control box does not power on.
Causes Solutions
The cable is the wrong
cable, incorrectly
connected, or
damaged.
Check that the power cable supplies 12 to
24 VDC and is negative conductive.
• A socket (positive) = 12 to 24 VDC
• E socket = Ground
Check that the power cable is connected to
the correct port (“Connectors” on page 3-8)
and see that the ends are securely fastened.
If the cable is damaged, contact your dealer
to purchase a new cable.
Problem
Screen display turns off by itself.
Causes Solutions
The fan may be
damaged, causing the
control box to
overheat.
Check that the fan is rotating.
If the fan is not rotating, it may be damaged
and needs to be replaced with new one.
Contact your dealer.
Contact your dealer for information on
replacing the fan.
To Next Page
Loading...
Need help?
General
