P/N 7010-0781
TOC
i
Table of Contents
Preface .................................................................. vii
Terms and Conditions ...................................................... vii
Manual Conventions ........................................................ ix
Chapter 1
Introduction .......................................................... 1-1
mmGPS 3D Paver Components ....................................... 1-1
Jobsite Components ......................................................... 1-3
Hand-held Controller with Pocket-3D ...................... 1-5
Machine Components ...................................................... 1-6
Daily Care and Preventative Maintenance ...................... 1-18
Chapter 2
Setting up the Jobsite and Pocket-3D ................ 2-1
Hand-held Controller and Pocket-3D .............................. 2-1
Setting Up the Base Station ............................................. 2-2
Base Station Initialization ......................................... 2-9
General Base Station Setup Rules and Notes ............ 2-11
Setting up PZL-1 .............................................................. 2-12
Equipment Setup: GPS .................................................... 2-15
Step 1: Create a Control Point File ........................... 2-15
Step 2: Setup and Initialize a Base
Station/Transmitter ................................................ 2-17
Step 3: Create a Range Pole Equipment
Configuration ......................................................... 2-19
Step 4: Setup the Rover Radio .................................. 2-21
Step 5: Setup the Rover Antenna .............................. 2-22
Step 6 for mmGPS: Setup the mmGPS Receiver ...... 2-22
Step 7: Connect to the Rover .................................... 2-23
Localizing with Pocket-3D .............................................. 2-24
Creating Files in Pocket-3D ............................................. 2-25
Creating a Points File ................................................ 2-25