Table of Contents
P/N 7010-0781
iii
Selecting a Machine Configuration .................... 3-46
Creating a Machine Configuration ..................... 3-47
Steer Indication ......................................................... 3-51
Steer to Polyline ........................................................ 3-51
PZS-MC Receiver ..................................................... 3-53
PZL-1 Transmitters ................................................... 3-54
Copying PZL-1 Transmitter Information ........... 3-55
Calibrate Sensors (Averaging) .................................. 3-56
Averaging Value Range: 1-100 .......................... 3-56
Valve Offsets ............................................................. 3-57
2D Control ................................................................. 3-59
Tools Menu ...................................................................... 3-59
Topo Survey .............................................................. 3-59
Position Check .......................................................... 3-61
Configure Radios ...................................................... 3-63
View Menu ...................................................................... 3-64
Main Window ............................................................ 3-65
Left Window ............................................................. 3-67
Right Window ........................................................... 3-68
Lower Window .......................................................... 3-69
Display Options ......................................................... 3-71
About 3DMC ............................................................. 3-72
Changing Cut/Fill Offsets ................................................ 3-73
Changing the Grade Indicator ................................... 3-73
Changing the Light Bar Scale ................................... 3-75
Elevation Control Key ..................................................... 3-76
Adjust Elevation in mmGPS Control ........................ 3-78
Adjust Elevation in 2D Control ................................. 3-79
Changing Offsets Using the Elevation Control Key . 3-79
Adjusting Valve Gain ................................................ 3-81
Viewing GPS Information ......................................... 3-82
GPS Status and Quality ...................................... 3-83
Screed Edge Position .......................................... 3-83
Monitor Satellites and Enter Mask Angle .......... 3-84
View Receiver Information or Reset Receiver ... 3-84
Satellite Planning Information ............................ 3-85
Viewing and Updating 3DMC Options ........................... 3-86
Setting the Elevation Offset and Locking On-grade . 3-87
To Next Page
Loading...
Need help?
General
