Connecting the Receiver and a Computer
P/N 7010-0935
2-21
6. For network connections, configure FTP Settings (optional) with
the following selections (Figure 2-9):
• TCP port – 21 (default value). This is the port on which the
receiver listens for an FTP connection. The receiver allows up
to five FTP connections at a time.
• Timeout – 600 (default value). This parameter sets the length
of time in seconds the receiver allows an inactive connection
to remain open. After this time, the receiver terminates the
unused connection.
7. If required, enter a Network Password to access the FTP server
(Figure 2-9).
Figure 2-9. Ethernet Connection Settings – FTP Network Example
8. Click Apply, and then OK to set the parameters.
9. Click ToolsReset receiver to restart the receiver.
10. Click FileDisconnect.
11. Connect the receiver and computer or a networking device (hub,
switch, etc) as described in “Establishing an Ethernet
Connection” on page 2-17.
Net-G3A_OM_Book.book Page 21 Thursday, May 14, 2009 8:49 AM
To Next Page
Loading...
Need help?
General
