Topcon RC-5A - Bluetooth Pairing Notes

33
6. SETTINGS FOR THE TOTAL STATION
● When "Track" is set
*1: Pressing [TRK On] when A.T. Setting is set to "None" will result in one of the following
operations being performed.
When "R.C." selected: Performs Turning operation then Auto Tracking
When "G.S." selected: Performs Auto Pointing then Auto Tracking
"Motor"
setting
Softkey
When "Track" set in "A.T. Setting"
When "None" set in
"A.T. Setting"
"Srch method" is R.C.
"Srch method" is G.S.
(Global Search)
[SRCH] Performs Auto Pointing then Auto Tracking Performs Auto Pointing
[DIST] Performs Turning
operation then distance
measurement/Auto
Tracking
Performs Auto Pointing
then distance
measurement/Auto
Tracking
Performs angle and
distance measurement
[RC] Rotates directly in the direction of the Remote
Controller then performs Auto Pointing
Rotates in the direction
specified by the Remote
Controller then performs
Auto Pointing
[<-RC] Rotates in a counterclockwise direction (from the
point of view of the Remote Controller) then performs
Auto Pointing/Auto Tracking
Rotates in a
counterclockwise
direction (from the point
of view of the Remote
Controller) then performs
Auto Pointing
[RC->] Rotates in a clockwise direction (from the point of
view of the Remote Controller) then performs Auto
Pointing/Auto Tracking
Rotates in a clockwise
direction (from the point
of view of the Remote
Controller) then performs
Auto Pointing
[RC Cont] Nullifies the current measurement position then
continues Turning operation/Auto Tracking
Nullifies the current
measurement position
then continues Turning
operation
[TRK On] Performs Turning
operation then Auto
Tracking
Performs Auto Pointing
then Auto Tracking
Performs Auto Tracking
*1