36
7. BASIC OPERATION
PROCEDURE Removing the battery
1. Slide down the catches on the battery cover to
open.
2. Push the battery up to release.
3. Close the battery cover. A click is heard when
the cover is secure. Make sure that both
catches on the battery cover have returned to
their original positions.
The Remote Controller should be set to "Master" when pairing the total station with the Remote
Controller for Bluetooth wireless communication for the first time. The Remote Controller searches for
the total station wireless device and initiates a connection.
1. Turn on the total station and select "Slave"in
communication settings.
"6. SETTINGS FOR THE TOTAL
STATION"
2. Turn on the Remote Controller while pressing
the SEARCH button . ● FAR flashes and
the Remote Controller searches for the total
station wireless device. When the search is
complete an audio tone sounds to indicate the
number of devices found. Proceed to step 3.
If the total station wireless device is not found
an audio tone sounds continuously and the
Remote Controller powers off automatically.
Check communication settings and conditions.
"2. PRECAUTIONS Precautions
concerning Bluetooth wireless
technology"
3. ● COM1 and ● FAR are lit when the audio
tone stops. When is displayed on the
status bar of the total station companion
device, press the FAR button to confirm
the pairing. The Remote Controller
automatically powers off.
7.2 Configuring Bluetooth Connections to the Total Station
To Next Page
Loading...
