Program the remote
Press the learn button on the control board for about 1 second
and then release, the buzzer will beep for a long sound and the
RUN LED light will flash and then be off. Then press the key on
the remote two times in 2 seconds, between the two times
HOLD ON FOR A MOMENT. The buzzer will beep for 8 short
sounds continuously (last for 2 seconds), meanwhile the LED
will flash and then be on steady. Now the remote has been
programmed successfully.
Erase all the remote codes
Press and hold the learn button until the buzzer beeps for 8 short sounds continuously (the RUN LED will be
off and finally returns to on simultaneously). Now all remote codes have been erased.
NOTE: Max. 120 remotes can be programmed for the opener. An External Receiver (optional) allows up
to 250pcs remotes to be programmed for the opener. TOPENS ERM12 Universal External Receiver is
available at TOPENS Store.
TOPENS ERM12 Universal External Receiver is also compatible with other brand swing gate opener,
sliding gate opener and garage door opener.
How to Use the Remote to Operate Your Gate Opener
Each remote has four buttons, from top to bottom are separately A, B, C and D. You
may use this remote to operate as many as 4 sets TOPENS swing gate openers or 1
set TOPENS sliding gate opener and 2 sets TOPENS swing gate openers.
1. Use this remote to only operate TOPENS swing gate opener A, B, C and D four
buttons share same function once they are programmed with TOPENS swing gate
opener. You may choose any button to program it with our swing gate opener. Every
press of the button is able to active the gate opener to work alternately
(open-stop-close-stop-open).
2. Use one remote to operate TOPENS swing gate opener & sliding gate opener at the
same time
All of TOPENS sliding gate opener have midway mode. Button B is designed to realize midway function
(refer to more details in our TOPENS sliding gate opener manual). So it is must program button A with
sliding gate opener, while you may program either C button or D button with TOPENS swing gate opener.
Wireless Keypad Programming
You can follow the below steps to program wireless keypad to the opener. Press the learn button on the
control board for about 1 second and release, the buzzer will beep for a long sound and the RUN LED light
will flash and then be off. Then press "OK" button on keypad. The buzzer will beep for 8 short sounds
continuously ((last for 2 seconds), with LED flashing and then returning to on which indicates the keypad has
been programmed successfully. You can use the default password “888888” to operate the opener after
programming. You can press “PIN” “8 8 8 8 8 8” and then press “OK” to confirm to operate the opener. Also
you can just press “OK” to stop the gate opener from running.
You can change the password of the keypad follow the below steps. Press “PIN” and then input the six digits
old password and then press ”PIN” again, the buzzer will beep for a long sound and then beep for a short
sound (RUN LED will flash at the same time). Input the six digits new password and then press the “PIN” to
To Next Page
Loading...
