Toro 04042 - Installing the Target Plate; Installing the Weight Rod

Note:Determinetheleftandrightsidesofthemachine
fromthenormaloperatingposition.
Note:Toinstalltheweightrodontoyourmachine,referto
theinstallationinstructionsinyourCuttingUnitOperator’s
Manual.
1
InstallingtheTargetPlate
Partsneededforthisprocedure:
1Targetplate
Procedure
1.Setupandpreparethecuttingunitasdescribedinthe
cuttingunitOperator’sManual.
2.Removethecenter,grass-shieldbolt(Figure3).
3.Installthetargetplatetothetopofthecuttingunit
usingtheboltthatyouremovedpreviously(Figure3).
1
2
G017294
Figure3
1.Center,grass-shieldbolt
2.Targetplate
2
InstallingtheWeightRod
Partsneededforthisprocedure:
1Weightrod
1Flange-headbolt
Procedure
1.Enlargethelowerholeontherightsideofthecutting
unitusinga9mm(23/64inch)drillbit(Figure4).
G026123
Figure4
2.LubricatetheO-ringontheweightrod.
3.InserttheO-ringendoftheweightrodintothe
previouslydrilledhole.
4.Securethethreadedendoftheweightrodtotheframe
usingaange-headbolt(Figure5).
11