Toro 04042 - Installing the Cutting Unit to the Traction Unit

1
2
G026124
Figure5
1.Flange-headbolt2.Weightrod
3
InstallingtheCuttingUnitto
theTractionUnit
Partsneededforthisprocedure:
2
Bolt(3/8x3/4inch)
Procedure
Note:Toinstalltheweightrodontoyourmachine,referto
theinstallationinstructionsinyourCuttingUnitOperator’s
Manual.
1.Placethemoweronitsdrumsonalevelsurface.
2.Lowerthekickstandandpushinthelockingpinto
lockthekickstandintheserviceposition(Figure6).
Note:Allowthemachinetorestonthelocked
kickstand.
Note:Placethekickstandinthispositionwhenever
youremovethereel.Thiswillkeepthemachinefrom
tippingbackwardontothehandle.
G017356
1
2
3
Figure6
1.Kickstand—storage
position
3.Kickstand—service
position
2.Lockingpin
3.Pushthecuttingunitunderthetractionunitandtothe
lefttoengagethetransmissioncoupling(Figure7).
Figure7
1.Transmissioncoupling
4.Maneuverthetractionunitframe(Figure8)forward
untilitengagesthecuttingunitpivotarms.
12