Toro 04044 - Grooming Reel (Counter Rotating Groomer Drive)

Greensmaster Flex 1800/1820/2100/2120Belt Driven Groomer (Optional) Page 8 − 14
Grooming Reel (Counter Rotating Groomer Drive)
Figure 10
1. RH groomer arm assembly
2. HOC nut (2 used)
3. Bushing (2 used)
4. Spring washer (2 used)
5. Lock nut (2 used)
6. LH groomer arm assembly
7. Cap screw (2 used)
8. Grooming reel assembly
9. HOC washer (2 used)
10. HOC screw (2 used)
11. O−ring
12. RH drive plate assembly
13. Shoulder bolt (2 used)
14. Driven gear (30T)
15. Lock nut
16. Front roller
17. Groomer drive gear (45T)
18. Bearing (2 used)
19. RH cutting unit side plate
20. Gasket
21. Flange head screw (5 used)
22. Groomer cover assembly
23. 47T idler gear
24. Flange nut (2 used)
25. Extension spring
26. Inner spring (2 used)
27. Outer spring (2 used)
28. LH support plate assembly
29. Support plate
30. Button head screw (4 used)
31. Roller shim
32. Socket head screw (4 used)
33. 43T idler gear
34. LH cutting unit side plate
35. Plow bolt (2 used)
33
1
3
4
5
6
7
9
10
12
13
14
15
17
18
20
21
22
23
24
25
26
27
28
29
30
31
32
7
13
18
24
9
10
2
2
8
16
11
19
34
35
35
125 ft−lb
(170 N−m)
120 in−lb
(13.5 N−m)
120 in−lb
(13.5 N−m)
17 to 21 ft−lb
(24 to 28 N−m)
Antiseize
Lubricant
Remove the grooming reel to replace individual blades,
to replace worn groomer components, to reverse the
blades on the shaft (if not equipped with carbide blades)
or to replace the grooming shaft.
Removal (Fig. 10)
1. Position machine on a clean and level surface with
engine stopped. Engage parking brake.
2. Remove the cutting unit from the machine and place
cutting unit on a flat work area.
3. Make sure that handle on groomer cover is rotated
toward front of machine so that groomer drive is en-
gaged.
4. Remove groomer cover assembly (item 22) and gas-
ket (item 20) from machine (see Groomer Cover (Count-
er Rotating Groomer Drive) in this section). Discard
gasket.
5. Carefully remove extension spring from anchor
points on RH drive plate (Fig. 11).
6. Remove the two (2) idler gears (43T and 47T) from
the RH drive plate assembly (Fig. 12). The bearings are
pressed into the gears.
7. Loosen cap screws (item 7) that secure front roller
shaft to groomer arms.