Toro 30317 - Setup

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Description
Qty.
Use
1
No parts required
–
Remove the shipping bracket and
shipping washers.
Handle assembly
1
Flanged bolt, 3/8 x 1 inch
4
2
Flange nut, 3/8 inch
4
Install the handle assembly.
Fuel tank with studs installed
1
Bolt, 5/16 X 7/8 inch
2
Lock nut, 5/16 inch
2
Washer, 5/16 inch
4
Hose clamp
1
Lock washer, 5/16 inch
2
3
Spring
2
Install the fuel tank.
Control rods
2
Cotter pin
2
Clevis Pin
2
Washer
2
4
Hairpin cotter pin
2
Install the control rods.
Hairpin cotter pin
2
5
Spacers 6
Install the hairpin cotter pins and
spacers.
Operator’s Manual
1
Engine Operator’s Manual
1
Parts Catalog
1
Safety Video
1
Registration Card
1
6
Oil drain hose
1
Read the Operator’s Manual and
watch the video before operating
the machine.
Note: Deter mine the left and right sides of the mac hine from the nor mal operating position.
Step
1
Removing the Shipping
Bracket and Shipping
Washers
No Parts Required
Procedure
1. R emo v e the center g ag e wheel n ut, 2 larg e
w ashers , angle brac k et and 1 small w asher
( Figure 3 ). Discard the 2 larg e w ashers and the
angle brac k et.
12