Toro 30381N - Page 16

Figure23
1.Cabmount
2.Rubbermount
10.Lowerthecabintopositionbyslowlyandevenly
looseningthejackingboltsoneachendofthejacking
tube(Figure24).
Figure24
1.Jackingbolts
2.Cabjacktube
11.Attherearmountingpoints,securethecabtothe
machinewithabolt(1/2x3inches),steelwasher(1/2
x2–1/2inches),rubberwasher(1/2x2–1/2inches)
andnut(1/2inch)(Figure25).Tightenallfourcab
mountboltsuntiltherubbermountsarecompressed
toathicknessof2.2cm(7/8inch).
Figure25
1.Rubbermount
2.2.2cm(0.875inch)
12.Tightentheboltsandnutssecuringtherearcabmounts
totheROPSposts(Figure26).Adjusttheoorjackif
theboltsarebindinganddifculttoremove.
Figure26
1.Cabmount3.Bolts&nuts
2.ROPSpost4.ROPSpost
13.Loosenthejackingboltsandremovethecabjacktube
fromthecutoutsinthecaboor(Figure27).
16