Toro 30413 - Page 24

Figure17
Note:Whenusing1inch(25mm),1-1/2inch(38
mm),oroccasionally2inch(51mm)height-of-cut,
movetheskidsandgagewheelstothehighest
position.
WingCuttingUnits
Toadjusttheheight-of-cutonthesidecuttingunits,add
orremoveanequalnumberofspacersfromthecastor
forks,positionthecastorwheelaxlesinthehighorlow
height-of-cutholesinthecastorforks,andsecurethe
pivotarmstotheselectedheight-of-cutbracketholes.
1.Positionthecastorwheelaxlesinthesameholes
inallofthecastorforks(Figure18andFigure20).
Refertothefollowingcharttodeterminethe
correctholeforthesetting.
2.Removethetensioningcapfromthespindleshaft
(Figure18)andslidethespindleoutofcastorarm.
Putthetwoshims(1/8inch[3mm])ontospindle
shaftastheywereoriginallyinstalled.Theseshims
arerequiredtoachievealevelacrosstheentire
widthofthecuttingunits.Slidetheappropriate
numberof1/2inchspacersontothespindleshaft
togetthedesiredheight-of-cut;thenslidethe
washerontotheshaft.
Figure18
1.Castorwheel4.Shims
2.Tensioningcap5.Axlemountingholes
3.Spacers
Refertothefollowingcharttodeterminethe
combinationsofspacersforthesetting.
Figure19
3.Pushthecastorspindlethroughthecastorarm.
Installtheshims(asoriginallyinstalled)andthe
remainingspacersontothespindleshaft.Installthe
tensioningcaptosecuretheassembly.
4.Removethehairpincotterandclevispinsfromthe
castorpivotarms(Figure20).
5.Rotatetensionrodtoraiseorlowerpivotarm
untilholesarealignedwithselectedheight-of-cut
bracketholesinthecuttingunitframe(Figure20
andFigure21).
24