Toro 30413 - Adjusting the Blade

6.Inserttheclevispinsandinstallthehairpincotters.
7.Rotatetensionrodcounterclockwise(ngertight)
toputtensiononadjustment.
Figure20
1.Castorpivotarm3.Clevispinandhairpin
cotter
2.Axlemountingholes4.Tensionrod
Figure21
AdjustingtheSkids
Theskidsshouldbemountedinthelowerposition
whenoperatinginheightofcutsgreaterthan2-1/2
inches(64mm)andinthehigherpositionwhen
operatinginheightofcutslowerthan2-1/2inches(64
mm).
Adjusttheskidsbyremovingtheangeboltandnuts,
positioningthemasdesired,andinstallingthefasteners
(Figure22).
Figure22
1.Skid
AdjustingtheCuttingUnitRollers
Thecuttingunitrollersshouldbemountedinthelower
positionwhenoperatinginheightofcutsgreaterthan
2-1/2inches(64mm)andinthehigherpositionwhen
operatinginheightofcutslowerthan2-1/2inches(64
mm).
1.Removetheboltandnutsecuringthegagewheelto
thecuttingunitbrackets(Figure23).
Figure23
1.Gagewheel
2.Aligntherollerandspacerwiththetopholesinthe
bracketsandsecurethemwiththeboltandnut.
AdjustingtheBlade
Toensureproperoperationofthecuttingunit,there
mustbe0.38-0.62inch(10-16mm)clearancebetween
thetipsofthewingandcentercuttingunitblades
(Figure24).
1.Raisecuttingunitsobladesarevisibleandblock
centerdecksectionsoitcannotfallaccidentally.
Wingdecksmustbehorizontaltocentercutting
unit.
2.Rotateacenterandadjoiningwingbladesothere
bladetipsarealigned.Measuredistancebetween
bladetips,distanceshouldbeapproximately
0.38-0.62inch(10-16mm)(Figure24).
25