Groundsmaster 4500 --D/4700--D
Page 2 -- 1
Product Records and Maintenance
Chapter 2
Product Records and Maintenance
Table of Contents
PRODUCT RECORDS 1.........................
MAINTENANCE 1..............................
EQUIVALENTS AND CONVERSIONS 2...........
Decimal and Millimeter Equivalents 2............
U.S. to Metric Conversions 2...................
TORQUE SPECIFICATIONS 3...................
Fastener Identification 3.......................
Using a To rque Wrench with an Offset Wrench 3..
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Inch Series) 4...............
Standard Torque for Dry, Zinc Plated and
Steel Fasteners (Metric Fasteners) 5..........
Other Torque Specifications 6..................
Conversion Factors 6.........................
Product Records
Insert Operator’s Manuals and Parts Catalog for your
Groundsmaster 4500-- D or 4700--D at the end of this
chapter. Additionally, insert Installation Instructions,
Operator’s Manuals and Parts Catalogs for any acces-
sories that have been installed on your Groundsmaster
at the end of this section.
Maintenance
Maintenance procedures and recommended service in-
tervals for your Groundsmaster are covered in the Trac-
tion Unit and Cutting Deck Operator’s Manuals. Refer to
those publications when performing regular equipment
maintenance. Several maintenance procedures have
break--in intervals identified in the Operator’s Manuals.
Refer to the Engine Operator’s Manual for additional en-
gine specific maintenance procedures.
Product Records
and Maintenance
To Next Page
Loading...
Need help?
General
