Toro 30881 - Page 174

Groundsmaster 4500 --D/4700--DHydraulic S ystem Page 4 -- 134
Lift Control Manifold Service (GM 4500--D)
1. Manifold body
2. Proportional relief valve (port TS)
3. Solenoid valve (port S6)
4. Solenoid coil (2 used)
5. Check valve (port CV)
6. Orifice (0.080)
7. Zero leak plug (#4)
8. Nut
9. Straight fitting
10. O--ring
11. Nut
12. O--ring
13. Relief valve (port RV)
14. Solenoid coil
15. Nut
16. Solenoid valve (port S5)
Figure 113
13
7
14
4
6
10
3
11
12
2
1
5
16
15
9
8
7
4
5ft--lb
(6.8 N--m)
5ft--lb
(6.8 N--m)
20 ft--lb
(27 N--m)
20 ft--lb
(27 N--m)
25 ft--lb
(34 N--m)
20 ft--lb
(27 N--m)
20 ft--lb
(27 N--m)
5ft--lb
(6.8 N--m)
25 ft--lb
(34 N--m)
25 ft--lb
(34 N--m)
UP
NOTE: The ports on the lift control manifold are marked
for easy identification of components ( e.g. P is the sup-
ply connection port and R7 is the location for the lift relief
valve). See Hydraulic Schematics in Chapter 9 -- Fold-
out Drawings to identify the function of the hydraulic
lines and cartridge valves at each port location.