Toro 4045 - Control Panel Layout; Engine Start and Stop Buttons; Drive;Drill Mode Selection Switch; Engine Speed Adjustment Switch

ControlPanel
g021834
1
2
3
4
5
6
7
8
9
10
Figure38
1.Engine-stopbutton
6.Ground-strike-resetswitch
2.Exit-sidelockout—reset
light
7.Exit-side-lockout—reset
switch
3.Exit-side
lockout—drill-enabled
light
8.Drive/drillswitch
4.Receiver-battery-status
light
9.Lightsswitch
5.Engine-startbutton10.Engine-speedswitch
Exit-sideLockout—ResetLight
Thislight(Figure38)illuminatesyellowwhentheexit-side
lockoutfunctionisturnedoffonexit-side-lockouttransmitter,
indicatingthatyoumayresetthesystem.
Exit-sideLockout—Drill-enabledLight
Thislight(Figure38)illuminatesgreenwhenthe
exit-side-lockoutfeaturehasbeenturnedoffandresetand
themachineisreadytodrill.
Exit-sideLockout—ResetSwitch
Pressthisswitch(Figure38)toenabledrillingoperationwhen
theresetlightilluminates.
Transmitter-battery-statusLight
Thislight(Figure38)illuminatesredwhenthebatteryon
theexit-side-lockouttransmitteristoolowtotransmit.Stop
drillingoperationsandxtheproblemwiththetransmitter
beforecontinuing.
Engine-startButton
Pressthisbutton(Figure38)tostarttheengine.Thekey
switchontherear,controlpanelmustbeintheOnposition.
Engine-stopButton
Pressthisbutton(Figure38)toimmediatelystoptheengine
andalldrillingoperations.Youmustpullthisbuttonout
beforeyoucanstarttheengineagain.
Ground-strike-resetSwitch
Pressthisswitch(Figure38)toresettheZap-Alertsystem
afteragroundstrikehasoccurredandbeenxed;referto
DeployingtheZap-alertSystem(page67).
Drive/DrillSwitch
Pressthetopofthisswitch(Figure38)toenablethedriveand
setupcontrolsorthebottomtoenabledrillandpipe-loader
functions.
LightsSwitch
Pressthetopofthisswitch(Figure38)toturnthemachine
lightsonorthebottomofthisswitchtoturnthemoff.
Engine-speedSwitch
•Pressandholdthetopofthisswitchtoincreasethe
enginespeed.
•Pressandholdthebottomofthisswitchtodecreasethe
enginespeed.
•Releasetheswitchtomaintainthecurrentenginespeed.
36