What causes a boom section not to turn off on my Toro 41165?
If a boom section on your Toro Paint Sprayer does not turn off, stop the spray system and pump, and turn off the sprayer. Remove the retainer from under the boom valve and pull out the motor and stem. Inspect all parts and replace any that appear damaged, because the valve may be damaged.
Why does a pressure drop occur when I turn on a boom on my Toro 41165 Paint Sprayer?
If you experience a pressure drop when you turn on a boom of your Toro Paint Sprayer, adjust the boom bypass valve if it is improperly adjusted. Also, remove the inlet and outlet connections to the boom valve and remove any obstructions if there is an obstruction in the boom valve body. Finally, remove and inspect all nozzles, because a nozzle filter might be damaged or clogged.
What to do if my Toro 41165 will not operate because the engine bogs down or stalls?
If your Toro Paint Sprayer will not operate or is sluggish in either direction because the engine bogs down or stalls, release the parking brake, because it might be set.
What causes a boom valve to leak on my Toro 41165 Paint Sprayer?
If a boom valve on your Toro Paint Sprayer is leaking, stop the spray system and pump, and turn off the sprayer. Disassemble the valve and replace the O-rings, because an O-ring might be deteriorated.
Why will my Toro 41165 Paint Sprayer not operate in either direction?
If your Toro Paint Sprayer will not operate in either direction, press the brake and shift the range selector into a gear, because the range selector might be in the Neutral position. Also, release the parking brake or check the linkage, because the parking brake was not released or is not releasing. For other issues, contact your Authorized Service Dealer, as the transmission might be broken, the control linkage might need adjustment or replacement or the drive shaft or wheel hub key might be damaged.
Why does the monitor not function on my Toro 41165?
If the monitor on your Toro Paint Sprayer does not function, connect the monitor cable if it is loose or disconnected. Contact your Authorized Service Dealer if the monitor or cable is damaged.
What to do if the boom actuator is not operating properly on my Toro Paint Sprayer?
If the boom actuator on your Toro Paint Sprayer is not operating properly, wait for the system to cool down before resuming operation, because a thermal breaker in the fuse block responsible for powering the actuator might have tripped due to overheating. If the thermal breaker trips repeatedly, contact your Authorized Service Dealer, as a thermal breaker in the boom actuator responsible for powering the actuator might have tripped or malfunctioned.
Why does the monitor display 6553.5 in the Application Rate setting on my Toro 41165?
If the monitor displays 6553.5 when in the Application Rate setting on your Toro Paint Sprayer, contact your Authorized Service Dealer, because the monitor is not receiving data from the speed sensor.
General| Power Source | Electric |
|---|---|
| Spray Pattern | Adjustable |
| Type | Airless |
| Maximum Pressure | 3000 psi |
| Hose Length | 25 ft |
| Tip Size | 0.015 in |
| Voltage | 120 V |
To Next Page
